Checking
Features Specific to this System
The Multec system is equipped with self - diagnosis. This means:
If the Multec control unit recognizes a fault in the system, it will be stored after a certain period of time. If any trouble codes are stored, the engine telltale in the instrument is switched on.
Note: For this the snapshot mode (F3 key) must be activated.
This allows sporadic faults (e. g. loose contacts) to be detected.
Important: Trouble codes can only be deleted using TECH 1. After completion of diagnosis with TECH 1, the ignition must be switched off at least once. Replace closure plug on the diagnostic plug and reconnect diagnostic plug to socket.