Multec- S X 14 XE / X 16 XE(L) F2:TROUBLE CODES
| Trouble Code | Information Sensor Cause of Fault | Remedy in F0:DATA LIST No. | Trouble Code Storage when... |
|---|---|---|---|
| 55 | REPLACE ECU | - | · Self- test of EEPROM: |
· Storage of the learned values and the settings in the EEPROM cannot be performed by the control unit
· On ignition ON, the fault is recognised immediately
Effects:
· The engine telltale is ON.
or
· Self- test of EEPROM:
· The EEPROM configuration number read by the control unit is incorrect.
· On ignition ON, the fault is recognised immediately
Effects:
· The engine telltale is ON.
· The engine does not start.
Note:
If trouble code 55 is stored, carry out following instructions:
Disconnect battery;
Reconnect battery;
Erase trouble code and read out trouble codes again;
| If trouble code 55 occurs again: replace control unit; |