Multec (X 12 SZ / X 16 SZ) F0: DATA LIST
| No. | TECH 1 Display | Conditions for Checking | Nominal Value | Trouble Codes | Terminal |
|---|---|---|---|---|---|
| 44 | IDLE ADJ. DRIVE | Nominal idle speed has not been reprogrammed (basic setting after control unit reset) | |||
| INACTIVE | |||||
| Nominal idle speed has been programmed. | ACTIVE | ||||
| Vehicles with AT | NOT USED | ||||
| Trouble - shooting: | Nominal Value: | Cause of Fault: |
(If nominal value is not attained)
· Program a new idle speed in the TECH 1 menu F6: F0: ADJUSTMENTS.
| · Read off value in the TECH 1 menu F0: DATA LIST no.: 44 | ACTIVE |
· In the TECH 1 menu F6: Fl ECU RESET
· Read off value in the TECH 1 menu F0: DATA LIST no.: 44
| INACTIVE | · Control unit defective |