Home/Opel/Corsa/Opel Corsa B (1993-2000)/Repair manual/Fuel Injection Systems/F0:Data List Test Step 22 Sec.air Pump Rel
Contents Wiring diagrams Section: Fuel Injection Systems All sections

F0:Data List Test Step 22 Sec.air Pump Rel Opel Corsa B

Multec- S X 14 XE / X 16 XE (L) F0:DATA LIST

No.TECH 1 DisplayConditions for CheckingNominal ValueTrouble CodesTerminal
22SEC.AIR PUMP RELEngine running at idle speed, cold
ACTIVE
52, 53A10
Engine running at idle speed, operating temperatureINACTIVE
Notes on Trouble-shooting:Nominal Value:Cause of fault:

(If nominal value is not attained)

· Ignition OFF

· Disconnect from base:

K12 secondary air injection relay

· Using multimeter, measure voltage

from: K12 base of secondary air injection relay Ter. 8

to: ground

higher than 11 V· F49 fuse defective

· Short circuit to ground or circuit interruption

from: K12 base of secondary air injection relay Ter. 8

to: battery +, Ter. 30

· Disconnect from base:

K58 fuel pump relay

· Bridge wiring harness plug

from: K58 base of fuel pump relay Ter. 2

to: K58 base of fuel pump relay Ter. 8

· Ignition ON

· Using multimeter, measure voltage

from: K12 base of secondary air injection relay Ter. 4

to: ground

higher than 11 V· Check according to data list no. 12 FUEL PUMP RELAY

· Using multimeter, measure voltage

from: K12 base of secondary air injection relay Ter. 6

to: groundlower than 0.1 V· Short circuit to voltage

from: K12 base of secondary air injection relay Ter. 6

to: K57 wiring harness plug for engine control unit Ter. A10

· K57 engine control unit defective

· Using multimeter, measure voltage

from: K12 base of secondary air injection relay Ter. 2 and Ter. 5

to: ground

lower than 0.1 V
· Short circuit to voltage

from: K12 base of secondary air injection relay Ter. 2 and Ter. 5

to: M27 secondary air injection pump

· Ignition OFF

· Using multimeter, measure resistance:

from: K12 base of secondary air injection relay Ter. 5

to: ground

lower than 2 W· Circuit interruption

from: K12 base of secondary air injection relay Ter. 5

to: ground

· Connect test lamp:

from: K12 base of secondary air injection relay Ter. 4

to: K12 base of secondary air injection relay Ter. 6

· Ignition ON

· Using TECH 1, carry out:

5:ACTUATOR TEST

SEC. AIR P.REL

Test lamp ON
· Short circuit to ground or circuit interruption

from: K12 base of secondary air injection relay Ter. 6

to: K57 wiring harness plug for engine control unit Ter. A10

· K57 engine control unit defective

· Ignition OFF

· Ignition ON

Test lamp OFF

· Bridge wiring harness plug

from: K12 base of secondary air injection relay Ter. 8

to: K12 base of secondary air injection relay Ter. 2M27 secondary air pump ON· Short circuit to ground or circuit interruption

from: K12 base of secondary air injection relay Ter. 2

to: M27 secondary air pump

· Circuit interruption

from: M27 secondary air pump

to: ground

· M27 secondary air pump defective

Note:

If M27 secondary air pump does not operate, the thermal protection switch inside the secondary air pump may have interrupted the circuit.

If nominal values are attained· K12 secondary air injection relay defective