Multec - S (C 16 XE) F0:DATA LIST
| No. | TECH 1 Display | Conditions for Checking | Nominal Value | Trouble Codes | Terminal |
|---|---|---|---|---|---|
| 20 | DEC. FUEL CUTOFF | Ignition ON, speed: | higher than 40 km / h, | ||
| 25 MPH | - | - | |||
| Constant speed | INACTIVE | ||||
| Deceleration | |||||
| ACTIVE | |||||
| Note: |
The deceleration fuel cutoff must be active at a speed higher than 40 km / h (25 mph), though it can be active at values lower than 40 km / h.
This value is an internal value of the control unit.
To carry out the deceleration fuel cutoff, the control unit requires the following data:
1. Throttle valve position
2. Speed signal
3. Engine speed
4. Hot wire mass air flow meter signal
If a signal is not fault - free, the control unit cannot correctly carry out the deceleration fuel cutoff
| Trouble - shooting: | Nominal Value: | Cause of Fault: |
(If nominal value is not attained)
| · In case of fault: | · Carry out test step 03,05,27 or 28 |