Table 2, Multec-S (C 16 XE) F2: TROUBLE CODE
Trouble
| Code | Information Sensor | ||
|---|---|---|---|
| Cause of Fault | Remedy in F0: | ||
| DATA LIST | Trouble Code Storage when... | ||
| 35 | IDLE AIR CONTROL | 08 | · Engine running at idle speed |
· System not in TECH 1 diagnostic mode
· Coolant temperature higher than 80 °C/176 °F
· Battery voltage lies in range of 8 to 16 volts
· Following trouble codes are not stored: 21, 22, 24
· Nominal idle speed is not maintained;
the deviation is greater than 125 rpm
· The above conditions must be satisfied for at least 20 s
Note:
If the speed sensor is not operational and trouble code 24 is not yet recognized, trouble code 35 can be set under certain circumstances.