Multec - S (C 16 XE) F0:DATA LIST
| No. | TECH 1 Display | Conditions for Checking | Nominal Value | Trouble Codes | Terminal |
|---|---|---|---|---|---|
| 41 | IDLE ADJUST | If the F0: DATA LIST No.: 39 is INACTIVE the nominal engine speed has not been altered or the control unit has been reset. | |||
| Ignition ON | - | - | |||
| Engine running at idle speed, at operating temperature | 900 rpm | ||||
| Engine running in partial load range, at operating temperature | |||||
| 950 rpm | |||||
| If the F0: DATA LIST No.: 39 is ACTIVE the nominal engine speed has been reprogrammed. | |||||
| Ignition ON | |||||
| Engine running at idle speed, at operating temperature | |||||
| The nominal engine speed set in F6: |
Miscellaneous Tests,
F0: Adjustments must appear in the display.
| Engine running in partial load range, at operating temperature | The nominal engine speed set in F6: |
Miscellaneous Tests,
F0: Adjustments,
increases by 50 rpm
| Trouble - shooting: | Nominal Value: | Cause of Fault: |
(If nominal value is not attained)
| · Test steps No. 39 and No. 40 OK? | · Control unit defective |