Multec-M (14 SE / C 14 SE / C 16 SE) F0:DATA LIST
| No. | TECH 1 Display | Conditions for Checking | Nominal Value | Trouble Codes | Terminal |
|---|---|---|---|---|---|
| 26 | DEC. FUEL CUTOFF | Ignition ON, speed: |
Constant speed
Deceleration
Note:
Deceleration fuel cutoff must be active at speeds above 80 km/h (50 mph).
| greater than 80 km/h, |
50 MPH
INACTIVE
ACTIVE
| - | - |
This value is an internal value of the control unit.
The control requires the following data to carry out the deceleration fuel cutoff:
1. Throttle valve position
2. Vehicle speed signal
3. Engine speed
| If a signal is not faultless, the control unit cannot carry out the deceleration fuel cutoff correctly. | ||
|---|---|---|
| Trouble-shooting: | Nominal Value: | Cause of Fault: |
| (If nominal value is not attained) |
· In the event of a fault:
| · carry out test step 05, 06 11 or 12 |