Multec- S X 14 XE / X 16 XE (L) F0:DATA LIST
| No. | TECH 1 Display | Conditions for Checking | Nominal Value | Trouble Codes | Terminal |
|---|---|---|---|---|---|
| 48 | TORQUE CONTROL | Vehicles with AT: |
Vehicle travelling at approx. 50 km/h (30 mph), constant speed
INACTIVE
| 75, 76 | E10 | ||
|---|---|---|---|
| Automatic transmission shifts | ACTIVE | ||
| Vehicles with MT: | NOT IN USE | ||
| Notes on Trouble-shooting: | Nominal Value: | Cause of fault: |
(If nominal value is not attained)
· Ignition OFF
· Disconnect wiring harness plug:
K85 AT control unit
· Ignition ON
· Using multimeter, measure voltage
from: K85 wiring harness plug for AT control unit Ter. 13
to: ground
· TECH 1 data list no. 48 TORQUE CONTROL
| higher than 11 V | |
|---|---|
| INACTIVE | · Short circuit to ground or circuit interruption |
from: K85 wiring harness plug for AT control unit Ter. 13
to: K57 wiring harness plug for engine control unit Ter. E10
· K57 engine control unit defective
· Bridge wiring harness plug
from: K85 wiring harness plug for AT control unit Ter. 13
to: ground
· TECH 1 data list no. 48 TORQUE CONTROL
| ACTIVE |
|---|
| · Short circuit to voltage |
from: K85 wiring harness plug for AT control unit Ter. 13
to: K57 wiring harness plug for engine control unit Ter. E10
· K57 engine control unit defective
Note:
| The TECH 1 display is only updated again after ignition OFF, ignition ON | If nominal values are attained | · K85 AT control unit defective |