Replace Valves - Camshaft Adjustment Opel Vectra C

Remove

1. 1. Open bonnet
2. 2. Place collecting basin underneath.
3. 3. Unclip wiring harness from cylinder head cover
4. 4. Remove 2x valve - camshaft adjustment (3) • Disconnect 2x wiring harness plug (1) • Unscrew 2x bolt (2) • Withdraw 2x valve - camshaft adjustment, from bearing block

Install

5. 5. Install 2x valve - camshaft adjustment • Insert 2x valve - camshaft adjustment, to stop – Coat seal rings with clean engine oil • Tighten 2x bolt 6 Nm • Connect 2x wiring harness plug
6. 6. Clip wiring harness to cylinder head cover
7. 7. Check engine oil level and correct if necessary.
8. 8. Close bonnet