Replace Oil Pressure Switch Opel Vectra C

Remove

1. 1. Detach ribbed V-belt
2. 2. Remove compressor • Unscrew 3x bolt (1) • Lay aside

3. 3. Place collecting basin underneath.
4. 4. Remove oil pressure switch • Disconnect wiring harness connector. – Push back heat shield • Unscrew oil pressure switch

Install

5. 5. Install oil pressure switch • Tighten oil pressure switch 20 Nm • Connect wiring harness plug – Push on heat shield
6. 6. Attach compressor • Tighten 3x bolt 22 Nm
7. 7. Attach ribbed V-belt
8. 8. Lower vehicle by its entire height
9. 9. Check engine oil level and correct if necessary.
10. 10. Close bonnet