Simtec F2:TROUBLE CODE TABLE
| Trouble Code | Information Sensor Cause of Fault | Remedy in F0:DATA LIST No. | Trouble Code Storage when ... |
|---|---|---|---|
| 59 | IMMOBILISER NO OR WRONG CODING | 01, 02 | · Immobiliser function in engine control unit is programmed incorrectly or not at all |
or
· Immobiliser function in engine control unit is deactivated
· Engine control unit recognises the imo signal from the immobiliser control unit without request
Effects:
· The engine telltale flashes
· Approx. 1 s after ignition ON, the injection function is blocked and the fuel pump switched off
Note:
| New control units are delivered with the status "immobiliser deactivated". Trouble code 59 remains stored until the immobiliser function in the control unit has been activated by calling up the relevant programming (see section 2.3.1.4.1). |