Multec-S X 14 XE / X 16 XE (L)5 F2:TROUBLE CODE TABLE
| Trouble Code | Information Sensor Cause of Fault | Remedy in F0:DATA LIST No. | Trouble Code Storage when ... |
|---|---|---|---|
| 55 | REPLACE ECU | - | · Self-test of EEPROM: |
The control unit cannot store the learned values and adjustments in the EEPROM
· With ignition ON, the fault is recognised immediately
Effects:
· The engine telltale is ON.
or
· Self-test of EEPROM:
· The EEPROM configuration number read by the control unit is not correct
· With ignition ON, the fault is recognised immediately
| Effects: |
· The engine telltale is ON.
· The engine does not start.
Note:
If trouble code 55 is stored, carry out the following instructions:
Disconnect battery;
Connect battery again;
Delete trouble code and read out trouble codes again;
If trouble code 55 occurs again: replace control unit;