C-39, Quad Driver Module (Qdm) Circuit
| C-39, Quad Driver Module (QDM) Circuit |
|---|
| Test | Work Order Description | Nominal Value |
| T01 | Check: Short to Voltage/Ground of Signal Circuit | |
| Select and enable diagnostic tester actuator test: QUAD DRIVER T. Refer to B-5 F5: ACTUATOR TEST Test09 QUAD DRIVER T. | Test okay? |
| Yes: E01 | No: E02 |
| C-39, Quad Driver Module (QDM) Circuit |
|---|
| Result | Cause Of Fault |
| E01 | Circuit interruption between: K57 Control Unit - Multec Wiring Harness Connector Terminal B12 & U16 Display - MID Wiring Harness Connector Terminal 21 or K57 Control Unit - Multec Wiring Harness Connector Terminal B13 & |
| Instrument Wiring Harness Connector Terminal 8 & K85 Control Unit - Automatic Transmission Terminal 29 |
| |
| E02 | Repair the concerned circuit/component. Note: Check light circuit to control unit terminal B10 Fuel consumption signal circuit (TRIP COMPUTER) to control unit terminal B12 Engine speed output circuit (TN-SIGNAL) to control unit terminal B13 |
| |
