B-07, F7: Programming Test Step T02 Immobiliser

B-07, F7: Programming Test Step T02 Immobiliser Opel Tigra A

B-07, F7: PROGRAMMING
Test	Work Order Description	Nominal Value
T02	Tester Display IMMOBILISER
	Ignition OFF Wait at least 12 s Note: Before the ignition is switched on, a waiting period of at least 12 s must have elapsed since last Ignition Off, otherwise the engine control unit does not send a new request for immobiliser signal to the immobiliser control unit (control unit power down time)
	If the following display appears during the test, an immobiliser signal has already been programmed:	ALREADY PROGRAM. REPROGRAM?
	If the following display appears during the test, the immobiliser control unit is not programmed: In order to program the engine control unit, the immobiliser control unit must be programmed first.	CHECK IMMOBILISER ECU!
	If the following display appears at the end of the test, a fault has occurred during programming. Take the following measures in the order listed below: Ensure that a control unit is installed in the vehicle; Check wires between the two control units.	IMMOBILISER NO SIGNAL RECEIVED!
	Concerned Terminals: D10
	Yes: -	No: C-04

B-07, F7: Programming Test Step T02 Immobiliser Opel Tigra A