F6:adjustments Idle Speed Opel Frontera A

Motronic M 1.5.4 System- Modification F6:ADJUSTMENTS

IDLE SPEED

Affected Terminals:

Possible Trouble Codes:

Note:

Before adjusting the idle speed and thus reprogramming the fixed values, it is useful if the amount that the engine speed is going to be increased or decreased is known, as once adjustment is completed, communication is broken off and has to be reestablished from scratch. If the newly programmed idle speed does not meet the requirements, the whole procedure has to be repeated.

It is simpler to establish at first the desired idle speed increase or decrease using the engine speed test described in F8: ECU control , and then programme this fixed value using the adjustment procedure described below.

Ignition ON

Engine OFF

Press key F6 in the system main menu, select the desired test using the arrow keys and confirm with YES. Follow the instructions in the diagnostic tester display.

Note:

The idle speed can be changed using the arrow keys:

· Arrow key up: engine speed increases in steps of 50, 100, 150 rpm

· Arrow key down: offset can be reduced again in steps of 50

The set idle speed is confirmed with ENTER .

When the ignition is switched off and on again after programming is completed, the new idle speed is stored in the EEPROM.

Ignition OFF

Ignition ON

If the display on the right appears after programming is completed, the programming was successful. The engine should then be started and the relevant data list parameter selected at idle speed (engine speed). The idle speed displayed must correspond to the adjusted value.

UPDATE

If the display on the right appears after programming is completed, a fault has occurred during programming. Carry out the following measures consecutively:

· Reading out trouble codes

· Repeat programming

· Carry out diagnostic tester selftest

· Check diagnostic tester cable for damaged insulation and shielding

· Reprogram with new control unit

UPDATE

FAILED!