Home ReviewsRefund
Home/Opel/Combo/Opel Combo C (2002-2011)/Repair manual/DOHC Diesel Engine/Special Service Tools
Contents Wiring diagrams Section: DOHC Diesel Engine All sections

Special Service Tools Opel Combo C

DOHC Diesel Engine 41 illustrations
KM-301Measuring Bridge
To measure piston projection
KM-313Slide Hammer
To remove axle shafts in conjunction with KM-902
KM-412-AEngine Overhaul Stand
To hold removed engine
KM-412-32Engine adapter
Engine mount in conjunction with KM-412-A
KM-468-BHolding Wrench
To wheel hub counterhold
KM-470-BAngular Torque Wrench
Tightening screwed joints with tightening angle
KM-471Adapter
To check pressurised cooling system in conjunction with cooling system tester
KM-498-BOil pressure gauge
To check engine oil pressure in conjunction with KM-232
KM-507-CRemover
To press tie rod joint out of steering knuckle
MKM-571-BDial gauge
MKM-596-ATemperature measuring instrument
MKM-604-DTorx Bit and Socket Set
To remove and install Torx bolts/nuts
MKM-610Torque Wrench, 1/2"
Range 30 – 130 Nm / 22 – 96 lbf. ft.
MKM-611Torque Wrench, 3/8"
Range 10 – 60 Nm / 7 – 44 lbf. ft.
KM-662-CHolding Wrench
Counterholding the belt pulley/crankshaft
MKM-669Torque Wrench, 1/2"
Range: 50 – 300 Nm
KM-796-ARemover
To open fuel system quick-release fittings
KM-902Remover
To remove axle shafts in conjunction with KM-313
KM-904Base Frame
To remove and install engine and transmission with KM-6312
KM-955Locking Pins
To lock ribbed V-belt and chain tensioner
KM-956Holding Wrench
Of which KM-956-1Counterholding the belt pulley/crankshaft
KM-2358Wire Cable
To suspend engine
KM-6130Locating Pin
To fasten Ribbed V-belt tensioner
KM-6168-ACentring Tool
To remove and install front axle in conjunction with KM-904
KM-6372Counterholding aid
For counterholding alternator drive disc when installing/removing
KM-6181Fixing, steering play
Steering intermediate shaft adjustment
KM-6182-1Pliers, straight
Removal/installation of compact clamps
KM-6182-2Pliers, curved
Removal/installation of compact clamps
KM-6182-3Pliers, flexible shaft
Removal/installation of compact clamps
KM-6347Bracket
Holding the camshaft sprockets to release them
Tightening the fastening bolts in conjunction with KM-956-1
KM-6394Engine/Transmission Mount
Aligning engine/transmission to front axle body
MKM-J-37228Separation Tool
To disconnect oil pan
EN-46775Centring cover, drive side, during installation
EN-46781To lock camshaft
To check timing
EN-46782Check compression
In conjunction with EN-46783
EN-46783Adapter
For checking compression in conjunction with EN-46782
EN-46785Rig pin
To check timing
EN-47655Injector diagnostic tool
For checking injectors on Common Rail diesel engines (Bosch injectors only)
EN-47656-1Pressure test plugs - connecting piece
For checking charge air system for leaks in conjunction with tyre inflator
EN-47656-2Pressure test plugs
For checking charge air system for leaks in conjunction with tyre inflator
EN-48391Remover/Installer
For removing/installing glow plug, width 8 mm

More articles — Engine and Engine Aggregates