Note. Only present in vehicles with air-conditioning
Remove
- 1. Remove ribbed V-belt
- 2. Remove ribbed V-belt guide roller (2) • Unscrew bolt
Install
- 3. Install ribbed V-belt guide roller • Tighten bolt 50 Nm
- 4. Install ribbed V-belt
Home/Opel/Corsa/Opel Corsa D (2007-2011)/Repair manual/DOHC Diesel Engine/How to Replace the Ribbed V-Belt Guide Roller
Contents
Wiring diagrams Section: DOHC Diesel Engine- Replace Metering Device
- Illustration of Air Ducting
- Illustration of Coolant Hoses
- Illustration of Charge Air Ducting
- Vacuum Routing in Engine Compartment
- Illustration of Common Rail System
- Illustration of Engine Management
- How to Remove and Install the Attaching Parts - Cylinder Head
- Check Con-Rod Bearing Clearance (Use Micrometer and Internal Measuring Device)
- Check Crankshaft Axial Clearance
- Check Crankshaft Bearing Clearance (With Plastigage)
- Check the Bearing Clearance of the Crankshaft (Use Micrometer and Internal Measuring Device)
- Z 17 DTR Diesel Engine
- How to Remove and Install the Manual Transmission from Engine
- Z 17 DTR Diesel Engine - Engine Number / Engine Code
- Repair Engine Using a Short Block Engine
- How to Check the Engine Oil Pressure
- Cylinder Head
- How to Check the Compression
- Valve Adjustment
- Check Engine Pressure Loss
- Cylinder Block
- Intake Manifold
- Replace Timing Chain
- Remove and Install Vacuum Pump
- Adjustment Data for Corsa-D Z 13 DTH (1.3 CDTI Ecotec) 66 kW
- Adjustment Data for Corsa-D Z 13 DTJ (1.3 CDTI Ecotec) 55 kW
- Adjustment Data for Corsa-D Z 13 DTR (1.3 CDTI Ecotec) 70 kW
- Adjustment Data for Corsa-D A 17 DTS (1.7 CDTI Ecotec) 96 kW
- Engine Oil with Oil Filter Change
- Replace Cylinder Block Ventilation Flange
- Replace Rear Engine Damping Block
- Replace Right Engine Damping Block Mounting Block
- Special Service Tools
- Specifications
- Checking and Adjustment Values
- Ribbed V-Belt
- Oil Circulation
- Crankshaft Drive, Cylinder Block
- Engine Number/code
- How to Measure the Oil Temperature
- Remove and Install Ribbed V-Belt
- Remove and Install Ribbed V-Belt Tensioner
- Remove and Install Torsional Vibration Damper
- Replace Hydraulic Chain Tensioner
- Replace Timing Chain Tension Rail
- Replace Timing Chain Sliding Rail
- How to Replace the Camshaft Sprocket
- Replace Crankshaft Sprocket
- Replace Oil Spray Nozzle (Pipe) Timing Chain
- How to Remove and Install the Engine Cover
- How to Check for Plane Surface the Cylinder Head
- How to Replace the Seal Ring - Rear Crankshaft
- How to Remove and Install the Flywheel
- Replace Oil Cooler / Heat Exchanger
- How to Remove and Install the Oil Pump
- How to Check the Oil Pump
- How to Remove and Install the Oil Pump Pressure-Regulating Valve
- How to Remove and Install the Oil Dipstick Guide Tube
- Replace Oil Baffle Plate
- Replace Intake Pipe for Oil Pump
- Replace Engine Damping Block Bracket Rear
- Replace Left Engine Damping Block Mounting Block
- Replace Valve Stem Seals
- How to Remove and Install the Cylinder Head
- Seal Camshaft Housing to Cylinder Head
- Replace Both Camshafts
- How to Replace the Camshaft Housing
- Replace One Piston And/or Con-Rod
- How to Replace the Piston Rings
- How to Replace the Con-Rod Bearing
- How to Check (With Plastigage) the Con-Rod Bearing Play
- Replace All Tappets, Hydraulic Valve Lifter
- DOHC Diesel Engine A17DTS - Engine Number/engine Code (Ot)
- Testing Ribbed V-Belt Tensioner
- Check Compression
- Check Engine for Leaks
- Removing and Installing Charge Air Pipe
- How to Check the Timing
- How to Adjust the Timing
- Replace Ribbed V-Belt
- Replace Ribbed V-Belt Tensioner
- How to Replace the Ribbed V-Belt Guide Roller
- Replace Front Toothed Belt Cover (Top)
- Replace Front Toothed Belt Cover (Lower)
- Replace Toothed Belt Drivewheel
- How to Replace the Toothed Belt Tensioner
- Replace Toothed Belt Guide Roller
- How to Remove and Install the Exhaust Manifold
- Replace Intake Manifold
- How to Replace the Seal Ring - Camshaft
- Removing and Installing Both Camshafts
- How to Remove and Install the Camshaft Housing Cover
- Check Camshaft Housing for Plane Surface
- How to Replace the Cup Tappets
- Detaching and Attaching Components, Cylinder Head
- How to Replace the Vacuum Pump
- Replace Exhaust Gas Recirculation Valve
- Replace Exhaust Gas Recirculation Cooler
- Replace Crankshaft Seal Ring (Rear)
- Replace Crankshaft (Front) Seal Ring
- How to Check for Plane Surface the Cylinder Block
- Check Con-Rod Bearing Clearance (With Micrometer)
- Replacing One Piston / Con-Rod
- How to Check the Crankshaft End Play
- How to Check the Crankshaft Out-Of-Round
- How to Remove and Install the Oil Pump Drive Gear
- How to Remove and Install the Oil Intake Pipe
- Replace Oil Pump Seal Ring
- How to Replace the Pressure Relief Valve in Oil Circuit
- How to Replace the Oil Pressure Sensor
- Replace Residual Oil Quantity Sensor
- Replace Oil Dipstick Guide Tube
- Replace Turbocharger Oil Feed Line
- How to Replace the Turbocharger Oil Return Hose
- How to Remove and Install the Lower Part of Oil Pan
- How to Remove and Install the Upper Part of Oil Pan
- Replace Oil Spray Nozzle
- How to Remove and Install the Coolant Pump Drive Gear
- Remove and Install Coolant Pump
- How to Replace the Fan Housing
- Remove and Install Coolant Pipe
- Repair Lower Radiator Mounting Pin
- Repair Condenser Mount
- Replace Right-Hand Engine Damping Block
- Repair Intercooler Mount
- How to Remove and Install the Starter
- How to Remove and Install the Alternator
- Special Tools (A17DTS)
- Toothed Belt
- Coolant Circuit
- Oil Circuit
- Crank Drive, Cylinder Block
- DOHC Diesel Engine (Z 17 DTR) - Engine Number/engine Code
- Check the Compression
- Replace Toothed Belt Tensioner
- Removing and Installing Exhaust Manifold
- Replace Cup Tappet
- Replace Exhaust Gas Return Valve
- How to Replace the Crankshaft Seal Ring (Front)
- Replace Oil Pump Seal Ring-
- Replace Excess Pressure Valve in Oil Circulation
- How to Remove from Engine and Install the Manual Transmission
- Replace Engine Damping Block (Rear)
- How to Replace the Right Hand Engine Damping Block
- Replace EGR Radiator
- How to Remove and Install the Crankshaft
- Check Crankshaft Bearing Clearance (With Micrometer Gauge Internal Measuring Device)
- How to Remove and Install the Engine
- Engine Maintenance Using a Section Engine
- Removing and Installing Camshaft Sensor
- Replace Sheathed Glow Plugs
- Replace Accelerator Pedal Module
- Engine Management
- Torque Guide Values
- Replace Cooer, Exhaust Gas Recirculation Valve
- Replace One Piston/con-Rod
- Check Crankshaft Bearing Clearance (Determine Bearing Play with Plastigage)
- Replace Exhaust Gas Recirculation Valve (M20-6 Mta Transmission)
- How to Remove from Engine and Install (M20-6 Mta Transmission) the Manual Transmission
- ABS 8
- ABS 8/ESP
- Adhesive Foiles
- Air Conditioning
- Airbag
- Anti-Theft Warning System-M
- Automatic Transmission Front Wheel Drive
- Battery
- Board Computer
- Body Equipment
- Brake Hydraulics, Brake Lines
- Brakes
- Car Level Control
- Clutch
- Clutch and Transmission
- Communication / Navigation
- Connector pinouts
- Cooling System
- Corrosion Protection
- DOHC Diesel Engine
- DOHC Petrol Engine
- Ecc Electronic Climate Control
- Electrical Equipment and Instruments
- Electrical Window Winders
- Electronic Module
- Engine and Engine Aggregates
- Engine Electrics
- Eps Electrical Power Steering
- Exhaust System
- Fittings, Hinges, Locks
- Frame
- Front End
- Front Wheel Brake
- Front Wheel Suspension
- Front Wheel Suspension, Wheels and Tyres
- Fuel and Exhaust System
- Fuel Injection Systems
- Fuel System
- Fuse Box
- General Vehicle Information
- Glass, Window Guides, Window Winders
- Graphic Info Display
- Headlamps, Lamps and Horn
- Heating, Ventilation
- Heating, Ventilation, Air Conditioning (HVAC)
- Immobiliser
- Info Display Ccrt 700
- Instruments, Telltales
- Lpg
- Maintenance, Body and Chassis Sheet Metal Parts, Frame
- Manual Transmission Front Wheel Drive
- Mid (Multi Info Display)
- Other Accessories
- Outside Rear View Mirror
- Paint
- Painting Repair Operations
- Painting Repair System
- Parkpilot
- Radio
- Rear Axle and Rear Wheel Suspension
- Rear Axle Front Wheel Drive
- Rear Wheel Brake
- Seats, Upholstery, Inner Trim Panels
- Sensors
- Service Brake, Parking Brake
- Servo Motors
- Sheet Metal Parts (Bolted)
- Sheet Metal Parts (Cement and Seal)
- Sheet Metal Parts (Welded)
- Sliding Roof
- Special Installations
- Steering Gear
- Steering Intermediate Shaft
- Steering Linkage
- Steering Wheel - Steering Column
- Stopp/start System
- Switches
- Switches, Control Unit, Relays, Ignition Lock
- TID (Triple Info Display)
- Trailer Hitch
- Trim Panels, Radiator Grille, Spoiler
- Trim Strips, Lettering, Coverings
- Turbo-Charging
- Wheels and Tyres
- Windscreen Wash/wipe System, Heated Screen
- Wiring Harnesses