Home/Opel/Calibra/Opel Calibra I (1990-1997)/Repair manual/Fuel Injection Systems/F2: Trouble Codes - Trouble Code 76 Continuous Torque Contr…
Contents Section: Fuel Injection Systems All sections

F2: Trouble Codes - Trouble Code 76 Continuous Torque Control Opel Calibra I

SIMTEC 56.1 F2: TROUBLE CODE TABLE

Trouble CodeInformation Sensor
Cause of FaultRemedy in

F0: DATA LIST

No.Trouble Code Storage when...

76

CONTINUOUS

TORQUE CONTROL

06, 14
· Vehicle rolling

· Ignition retard load reduction longer than 2.5 s

(ignition retard load reduction too long)

· Conditions must be fulfilled for at least 3 s

Effects:

· The ignition retard load reduction is blocked for 10 s. If the fault occurs for the third time, the ignition retard load reduction is deactivated until "ignition OFF". If a valid ignition retard load reduction action occurs before the third incorrect attempt, the trouble - shooting counter is cleared and the ignition retard load reduction, signal is observed again.