SIMTEC 56.1 F2: TROUBLE CODE TABLE
| Trouble Code | Information Sensor |
|---|---|
| Cause of Fault | Remedy in |
F0: DATA LIST
| No. | Trouble Code Storage when... |
15
| COOLANT TEMP. |
VOLTAGE HIGH
| 08 |
|---|
| · Coolant temperature less than - 37 °C / - 34.6 °F |
(short circuit to voltage or circuit interruption)
· Condition must be fulfilled for at least 1 s
Replacement values:
· With ignition ON and trouble codes 69 and 71 not recognized, the intake air temperature is taken as the starting value
· With ignition ON and trouble code 69 or 71 recognized, 10 °C / 50 °F is taken as the starting value
· If a plausible measured value has already been produced for the coolant temperature, it is used as the starting value
· The starting value' is increased by 1 °C / 1.8 °F every 146 cycles (1 cycle 720 °CA) to a maximum value of 99 °C / 210 °F
This value is used for the remaining engine operation.
Effects:
· All adaptation except knock adaptation, throttle valve adaptation and idle speed adjuster adaptation are blocked
· Controlled canister purge valve regulation is blocked and the controlled canister purge valve is closed