Home/Opel/Corsa/Opel Corsa D (2007-2011)/Repair manual/DOHC Petrol Engine/Replace Intake Camshaft Position Sensor

Contents

Wiring diagrams Section: DOHC Petrol Engine

All sections

Replace Intake Camshaft Position Sensor Opel Corsa D

DOHC Petrol Engine 1 illustration

Remove

1. Open bonnet
2. Switch off ignition
3. Remove intake camshaft position sensor (2) • Disconnect wiring harness connector. • Unscrew bolt (1)

Replace Intake Camshaft Position Sensor

Install

4. Clean sealing surfaces.
5. Install intake camshaft position sensor • Tighten bolt – Tightening torque 6 Nm . • Connect wiring harness plug

Note. Do not damage seal ring when installing.

6. Close bonnet