Starter Ring Gear, Remove and Install
| .D. ICON01.tif | 0,75 | 0,75 | tiff;; Remove, Disconnect |
Flywheel - see corresponding operation.
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
|---|---|---|---|
| To facilitate separation, centre punch starter gear below one tooth gap and drill to a depth of 8 mm / 0.31 in. using a 6 mm / 0.24 in. drill. | |||
| .P. A6908.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
| Separate starter ring gear with chisel on the drilling point. | |||
| .P. A7035.tif | 9 | 7,5 | tiff;; |
| .D. ICON04.tif | 0,75 | 0,75 | tiff;; Assemble |
Starter ring gear to flywheel.
Heat starter ring gear evenly to 180 °C / 356 °F to 230 °C / 446 °F (yellow paint mark).
| .D. ICON02.tif | 0,75 | 0,75 | tiff;; Install, Connect |
|---|---|---|---|
| Flywheel - see corresponding operation in this group. | |||
| .P. C5930.tif | 9 | 7,5 | tiff;; |
| .D. ICON06.tif | 0,75 | 0,75 | tiff;; Inspect |
| Lateral run - out of starter ring gear. | |||
| .P. C5931.tif | 9 | 7,5 | tiff;; |