Flywheel - see operation "Flywheel Remove and Install".
Disassemble
Drill starter ring gear below tooth gap approx. 8 mm deep with 6 mm diameter drill.
Disassemble
Starter ring gear from flywheel – use chisel above drilled hole to split ring gear.
Assemble
Starter ring gear to flywheel - heat starter ring gear evenly to 200° C.
Install
Flywheel - see operation "Flywheel Remove and Install".
Measure
Lateral run-out of starter ring gear - use dial gauge.
Maximum run-out is 0.5 mm.
