DTC P1595-B: SPEED CONTROL SOLENOID CIRCUITS Chrysler LHS II

Note. For connector terminal ID, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS article.

1. Using a DVOM, check resistance of speed control brake switch output circuit between brake switch connector and speed control servo 4-pin connector. See «SPEED CONTROL SERVO CONNECTOR WIRE IDENTIFICATION»(ref-576-S09698476912000030800000) table and «BRAKE SWITCH CONNECTOR WIRE IDENTIFICATION»(ref-576-S35005886492000030800000) table. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open brake switch output circuit. Perform «TEST VER-4A: SPEED CONTROL VERIFICATION»(ref-576-S16464623272000030800000) .
2. Check brake switch adjustment. See DISC & DISC article in BRAKES section. If brake switch adjustment is okay, replace brake switch. Perform «TEST VER-4A: SPEED CONTROL VERIFICATION»(ref-576-S16464623272000030800000) . If brake switch adjustment is not okay, adjust brake switch as necessary.