Input Speed Sensor, Clutch Pedal Position Sensor - Removal & Installation: Specifications Volvo S60 I

Fit torque converter screws.

Note. Use new screws, Torx TX50.

Align the torque converter to the carrier plate, by means of pulling round the engine with the nut to the crankshaft pulley and turning the torque converter.

Fit all screws, 6, loosely. Insert the screws as far as the screw heads sit against the carrier plate. Tighten in accordance with: Summary of tightening torques for specific components.

Note. Remove the socket wrench from the crankshaft.

Scheme 2054

Lift up the engine/gearbox. Check that the engine/gearbox is in horizontal position.

Raise the vehicle.

Scheme 2055

Install

1. the rear engine mounting, 3 x M10, to the gear box. Tighten
2. the screw to the engine pad/steering gear loosely.

Fit screws for engine pads and torque rod bracket in gearbox

Install

1. the screws, M10, to the front and rear engine pads. Tighten

Note. Use new screws.

1. the torque rod bracket to the gearbox. Tighten in accordance with: «Summary of tightening torques for specific components»(ref-415455-S06042927612011081500000).

See also:
• Summary of tightening torques for specific components
• Summary of tightening torques for specific components