MULTEC Central Fuel Injection (C 16 NZ 2, 18 NZ, C 18 NZ) F2:TROUBLE CODE TABLE
Trouble
| Code |
Information Sensor
| Cause of Fault | Remedy in |
F0:DATA LIST
| No. | ||
|---|---|---|
| Trouble Code Storage when ... | ||
| Remarks | ||
| 64 | EST LINE | |
| VOLTAGE LOW | 19 | · The control unit has determined a voltage at outputTer. D 10 to ignition module (EST lead) during the starting operation which does not correspond to the nominal value (10 consecutive 12 V to 0 V transitions were not registered) |
If trouble code 64 was recognized, the EST lead is switched off. The engine does not start.