MULTEC Central Fuel Injection (C 16 NZ 2, 18 NZ, C 18 NZ) F2:TROUBLE CODE TABLE
Trouble
| Code |
Information Sensor
| Cause of Fault | Remedy in |
F0:DATA LIST
| No. | |
|---|---|
| Trouble Code Storage when ... | |
| Remarks | |
| 42 | EST LINE |
| VOLTAGE HIGH | 19 |
| · The control unit has determined a voltage at outputTer. D 10 to the ignition module (EST lead) during starting which does not correspond to the nominal value |
(10 consecutive 12 V to 0 V transitions were not registered)
· (Short circuit to battery voltage)
If trouble code 42 was recognized, the EST lead is switched off. The engine does not start.