Home ReviewsRefund
Home/Opel/Corsa/Opel Corsa B (1993-2000)/Repair manual/DOHC Petrol Engine/Special Service Tools
Contents Wiring diagrams Section: DOHC Petrol Engine All sections

Special Service Tools Opel Corsa B

DOHC Petrol Engine 7 illustrations

Special Service Tools

KM-135Adapter
To measure engine oil pressure in conjunction with KM-498-B
KM-194-ESpark Plug Key
To remove/install spark plug
KM-235-DInstaller
To install crankshaft seal ring
KM-340-30Drift for Valve Seat Cutter Set KM-340-G
KM-348Spring Compressor
To compress
valve springs, cylinder head removed
KM-412Engine Overhaul Stand
To hold the removed engine

Special Service Tools

KM-412-18Adapter
To hold engine in conjunction with KM-412
KM-427Remover / Installer
To install guide pins into engine block
KM-460-BRemover
To remove drive shafts from transmission housing
KM-470-BAngular Torque Wrench
To tighten cylinder head bolts
KM-471Adapter
To check pressurised cooling system in conjunction with cooling system tester
KM-498-BOil Pressure Manometer
To check the engine oil pressure in conjunction with KM-135

Special Service Tools

KM-574Remover/Installer
To remove/ install ignition coil unit
MKM-596-ATemperature Gauge
To measure oil temperature
MKM-604-DTorx Bit and Socket Set
To remove/install Torx bolts
MKM-610Torque Wrench 1/2" Drive
Range 30 to 130 Nm / 22 to 96 lbf. ft.
MKM-611Torque Wrench 3/8" Drive
Range 10 to 60 Nm / 7 to 44 lbf. ft.
KM-634Installer
To install piston pins

Special Service Tools

KM-652Flywheel Locking Device
To lock flywheel
KM-658Installer
To install rear crankshaft seal ring
MKM-669Torque Wrench 1/2" Drive
Range 50 to 300 Nm / 37 to 221 lbf. ft.
MKM-883-1Engine Bridge
alternative to KM-263-B
KM-902Remover
To remove axle shafts
KM-952Positioning Pin
To lock crankshaft in TDC position

Special Service Tools

KM-953Fixing Tool
To position the camshaft at 1st cylinder "TDC"
KM-954Fixing Tool
To position phase sensor disc for camshaft
KM-955Locking Pins
To lock ribbed v-belt and chain tensioner
KM-956Holding Wrench
To counterhold crankshaft hub - remove and install
KM-957Adapter
To compress valve spring with KM-348 (cylinder head removed)
KM-958Installer
To insert valve stem seals

Special Service Tools

KM-959Installation Wrench
For tensioning tension roller during removal and installation of ribbed v-belt (M10)
KM-960Installer
To install crankshaft seal ring in timing case
KM-961Reamer 5 mm
To ream valve stem bores
KM-2358Engine Lifter Shackles
To suspend engine
KM-6009Remover/Installer
To remove/ install ignition coil unit
KM-6017Installation Wrench
For tensioning tension roller during removal and installation of ribbed v-belt (M12)

Special Service Tools

KM-6054Engine Mount
To remove and install engine
KM-J-34730-91Pressure Tester
To check fuel pressure

More articles — Engine and Engine Aggregates