Remove
- 1. Open bonnet
- 2. Disconnect battery • Detach earth connection from earth terminal – Slacken nut
- 3. Remove mixture regulator oxygen sensor (1) • Disconnect wiring harness connector (3) • Unclip wiring harness (2) from bracket
Install
- 4. Install oxygen sensor mixture regulator • Tighten oxygen sensor 40 Nm • Clip wiring harness into bracket • Fix wiring harness plug
- 5. Connect battery • Attach ground connection to ground terminal – Tighten nut
- 6. Program volatile memories
- 7. Close bonnet