- 1. Open bonnet
- 2. Raise vehicle by its full height
- 3. Detach charge air pipe (2) • Undo 2x clamps (1) • Remove charge air pipe
- 4. Detach wiring harness plug from engine control unit • Release 2x wiring harness plugs (1) and disconnect
- 5. Remove atmospheric pressure sensor (2) • Disconnect wiring harness connector (3) • Unscrew bolt (1)
Install
- 6. Install atmospheric pressure sensor • Tighten bolt • Fix wiring harness plug
- 7. Connect 2x wiring harness plugs to engine control unit
- 8. Install charge air hose with charge air pipe • Attach 2x clamps
- 9. Close bonnet