Home ReviewsRefund Car not listed?
Home/Opel/Vivaro/Opel Vivaro A (2001-2011)/Repair manual/DOHC Diesel Engine/Special Service Tools (Group J)
Contents Wiring diagrams Section: DOHC Diesel Engine All sections

Special Service Tools (Group J) Opel Vivaro A

DOHC Diesel Engine 26 illustrations
DT-48354Installer
To install output seal to transmission housing, left side
EN-47632Cleaner
To clean fuel injector bores in cylinder head
EN-48082Engine Support Adapter
Used with KM-6210-A to support engine and transmission
EN-48330Positioning Pin
To position crankshaft with No. 1 piston at top dead centre
EN-48331Reset Tool
To reset sprung camshaft drive gear
EN-48332Holding Tool
To hold camshaft drive gear
EN-48333Adapter
To check cylinder compression. Used in conjunction with KM-533-1
EN-48334Front Pulley Counterhold
To counterhold front pulley. Used in conjunction with KM-956-1
EN-48991Leak-off Measurement Tool
To measure fuel injector leak-off performance
EN-49069Installer
To install crankshaft seal ring, rear
EN-50143Fuel Injector Remover
To remove fuel injectors
KM-301Measuring Bar
Use with MKM-571-B for checking piston protrusion
KM-412Engine Overhaul Stand
To hold removed engine
KM-412-38Engine Mounting Adaptors
Used with KM-412 to hold removed engine
KM-475-ATrim Remover
To remove wheel arch liner
KM-498-BFluid Pressure Gauge
To indicate engine oil pressure during test
KM-507-CRemover
To release tie rod end from steering knuckle
KM-533-1Adapter
Used in conjunction with EN-48333
KM-652Flywheel Holder
To lock flywheel
KM-812Pipe Spanner
To remove and install high pressure pipes
KM-956-1Handle
Used in conjunction with EN-48334
KM-6130Locating Pin
To lock ribbed V-belt tensioner
KM-6165Alignment Tool
To install clutch assembly to flywheel
KM-6210-AEngine Support
To support installed engine and transmission
KM-6218Remover
To release drive shaft from wheel hub spline
KM-6286Adapter
Used in conjunction with KM-498-B (with air conditioning)
KM-6404Adapter
Used in conjunction with KM-498-B (without air conditioning)
KM-6434Installer
To install output seal to transmission housing, right side
KM-J-37228Seal Breaker
For cutting through sealant to separate components
MKM-571-BDial Gauge
Used in conjunction with KM-301 for checking piston protrusion
MKM-667Pressure and Vacuum Pump
For checking pressure of turbocharger control actuator

More articles — Engine and Engine Aggregates