Home ReviewsRefund
Home/Honda/Civic/Honda Civic VIII рестайлинг (2008-2011)/Repair manual/Testing & Diagnostics/DTC P0369: CMP Sensor Circuit Intermittent Interruption
Contents Section: Testing & Diagnostics All sections

DTC P0369: CMP Sensor Circuit Intermittent Interruption Honda Civic VIII рестайлинг

Testing & Diagnostics ~340 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Turn the ignition switch to ON (II).
  2. Clear the DTC with the HDS.
  3. Start the engine, and let it idle for 10 seconds.
  4. Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 8 . NO -Go to step 5.
  5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
  6. Check the CMP B NOISE in the DATA LIST with the HDS. Are 0 counts indicated? YES -Go to step 7. NO -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CMP sensor and the ECM/PCM.
  7. Turn the ignition switch to LOCK (0).
  8. Check for poor connections or loose terminals at these locations: CMP sensor ECM/PCM Engine ground Body ground Are the connections and the terminals OK? YES -Go to step 8. NO -Repair or replace the connections or the terminals, then go to step 11 .
  9. Check for damage to the CMP sensor pulser plate (see «CMP PULSE PLATE REMOVAL AND INSTALLATION»(ref-255508-S35605648342007060300000) ). Is the pulser plate damaged? YES -Replace the CMP sensor pulser plate (see «CMP PULSE PLATE REMOVAL AND INSTALLATION»(ref-255508-S35605648342007060300000) ), then go to step 11 . NO -Go to step 9.
  10. Replace the CMP sensor (see «CKP SENSOR REPLACEMENT»(ref-355126-S30056044322010012000000) ).
  11. Turn the ignition switch to ON (II).
  12. Reset the ECM/PCM with the HDS.
  13. Do the ECM/PCM idle learn procedure (see «ECM/PCM IDLE LEARN PROCEDURE»(ref-255517-S24591238122007060300000) ).
  14. Start the engine, and let it idle for 10 seconds.
  15. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0369 indicated? YES -Check for poor connections or loose terminals at the CMP sensor and the ECM/PCM, then go to step 1 . NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the «INDICATED DTC'S TROUBLESHOOTING»(ref-355126-S38482784232010012000000) .

More articles — Pgm-Fi System (R18A1 Engine)