Home ReviewsRefund
Home/Honda/Civic/Honda Civic VIII рестайлинг (2008-2011)/Repair manual/Testing & Diagnostics/DTC P0111: IAT Sensor Circuit Range/Performance Problem
Contents Section: Testing & Diagnostics All sections

DTC P0111: IAT Sensor Circuit Range/Performance Problem Honda Civic VIII рестайлинг

Testing & Diagnostics ~385 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Check for poor connections or loose terminals at ECT sensors 1 and 2, and the IAT sensor. Are the connections and terminals OK? YES -Go to step 2. NO -Repair the connectors or terminals, then go to step 15 .
  2. Remove the MAF sensor/IAT sensor (see «MAF SENSOR/IAT SENSOR REPLACEMENT»(ref-355119-S38118255712010012000000) ).
  3. Allow the IAT sensor to cool to ambient temperature.
  4. Note the ambient temperature.
  5. Connect the MAF sensor/IAT sensor to the 5P connector, but do not install the sensor onto the air cleaner.
  6. Turn the ignition switch to ON (II).
  7. Quickly note the value of the IAT SENSOR in the DATA LIST with the HDS.
  8. Compare the value of IAT SENSOR and the ambient temperature. Does the value of IAT SENSOR differ 5.4°F (3°C) or more from the ambient temperature? YES -Go to step 13 . NO -Go to step 9.
  9. Disconnect the MAF sensor/IAT sensor from the 5P connector.
  10. Using a heat gun, blow hot air on the MAF sensor/IAT sensor for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.
  11. Connect the MAF sensor/IAT sensor to the 5P connector, but do not install the sensor onto the air cleaner.
  12. Check the IAT SENSOR in the DATA LIST with the HDS. Does the IAT SENSOR change 59°F (33°C) or more from the ambient temperature? YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM. NO -Go to step 13.
  13. Turn the ignition switch to LOCK (0).
  14. Replace the MAF sensor/IAT sensor (see «MAF SENSOR/IAT SENSOR REPLACEMENT»(ref-355119-S38118255712010012000000) ).
  15. Turn the ignition switch to ON (II).
  16. Reset the ECM with the HDS.
  17. Do the ECM idle learn procedure (see «ECM IDLE LEARN PROCEDURE»(ref-255526-S39475388272007060300000) ).
  18. Check for Pending or Confirmed or DTCs with the HDS. Is DTC P0111 indicated? YES -Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM, then go to step 1 . NO -Troubleshooting is complete. If any other Pending or Confirmed or DTCs are indicated, go to the «INDICATED DTC'S TROUBLESHOOTING»(ref-355119-S39784062052010012000000) .

More articles — Pgm-Fi System (K20Z3 Engine)