Remove
- 1. Release 2x protective panelling from front panelling • Remove 4x clip (1)
- 2. Release front panelling from lower front body panel • Remove 3x bolt (1)
- 3. Lower vehicle
- 4. Release front panelling from 2x front wing • Remove 2x screw (1)
- 5. Release front panelling from upper front body panel • Remove 2x clip (3), 4x bolt (2)
- 6. Remove front panelling from vehicle • Release front panelling from 2x side bracket (1) – Pull off • Disconnect 2x harness connector from 2x front fog lamp (if installed)
Note. 2x technician are required.
- 7. Remove horn (1) from upper front body panel • Disconnect harness connector (2) • Remove bolt
- 8. Remove front air deflector panel from vehicle • Remove 4x clip
- 9. Remove oil pressure switch (1) from engine • Place collecting container below • Disconnect harness connector (2)
Install
- 10. Install new oil pressure switch (1) 13 Nm to engine • Apply suitable sealant to threads of oil pressure switch • Connect harness connector (2)
- 11. Install front air deflector panel to vehicle • Install 4x clip
- 12. Install horn (1) to upper front body panel • Install bolt • Connect harness connector (2)
- 13. Install front panelling to vehicle • Connect 2x harness connector to 2x front fog lamp (if installed) • Secure front panelling to 2x side bracket (1) – Push on
Note. 2x technician are required.
- 14. Secure front panelling to upper front body panel • Install 4x bolt (2), 2x clip (3)
- 15. Secure front panelling to 2x front wing • Install 2x screw (1)
- 16. Raise vehicle
- 17. Secure front panelling to lower front body panel • Install 3x bolt (1)
- 18. Secure 2x protective panelling to front panelling • Install 4x clip (1)
- 19. Lower vehicle