According to vehicle, the diagnostic equipment to be used is different
- DIAG 2000: all vehicles
- TEP 92: all vehicles, up to and including the launch of the 206
- BIP 722: all vehicles
DIAG 2000
Enables
- Identification
- Fault reading
- Parameter measurements
- Erasing the faults
- The actuator test
- Following the diagnostics flow charts for each fault or each customer complaint (symptom)
The harness tester permits
- Measurements on electrical circuits (automatic, semi-automatic and manual measurements)
- Simulation of component operation
These tests are linked to the diagnostics flow charts but can also be carried out independently
According to vehicle, connection is to: the central socket 16V.NR
For electrical checks use adapter(s) 88V.GR (reference C-1224-Z)
Peugeot on-board fault recorder (TEP 92)
Enables
- Identification
- Fault reading
- Parameter measurements
- Erasing the faults
- The actuator test
- The advance adjustment
Connection is to: centralised socket 16V.NR
Peugeot electrical break-out box (B.I.P. 722)
Enables
- Measurements on electrical circuits
- Simulation of component operation
Connection to the control unit 1320, the 88V.GR adapter must be used (reference C-1224-Z)
Connection to the double relay 1304, use: black and white 2 x 15 way adaptor (reference 9799-95)