Home/Opel/Meriva/Opel Meriva A (2003-2011)/Repair manual/Fuel Injection Systems/Replace Mixture Regulator Lambda Sensor

Contents

Wiring diagrams Section: Fuel Injection Systems

All sections

Replace Mixture Regulator Lambda Sensor Opel Meriva A

Fuel Injection Systems 1 illustration

Remove

1. Open bonnet
2. Remove mixture regulator lambda sensor (1) • Disconnect wiring harness connector (3) • Unclip wiring harness from bracket (2) • Remove carefully using KM-6129

Replace Mixture Regulator Lambda Sensor

Install

3. Fit mixture regulator lambda sensor • Coat thread of mixture regulator oxygen sensor with assembly paste • Tighten oxygen sensor with KM-6129 40 Nm • Connect wiring harness plug and clip in place

Note. Only when re-using the oxygen sensor - new oxygen sensors are already pre-treated

4. Close bonnet