How to Remove and Install the Starter Opel Agila A

Remove

1. 1. Open bonnet
2. 2. Disconnect battery • Detach ground cable • 1 fastening nut
3. 3. Detach relay holder (1) and preheating control unit (2) • Unclip from bracket • Lay aside relay holder and preheating control unit

4. 4. Detach shift cables (3) • Unclip from ball heads • Release retainer (1) in direction of arrow and remove from bracket (2)

Note. Mark order of shift cables

5. 5. Loosen top of starter (1) • Remove closure plug • Upper fastening bolt (3)

Important. Make sure that the fastening bolt does not fall into the clutch housing

6. 6. Lift vehicle
7. 7. Detach wiring harness • From starter • 2 fastening nuts
8. 8. Remove starter • Lower fastening bolt (2)

Install

9. 9. Install starter • Lower fastening bolt – Tightening torque 25 Nm
10. 10. Attach wiring harness • To starter • 2 fastening nuts
11. 11. Lower vehicle
12. 12. Fasten top of starter • Upper fastening bolt – Tightening torque 25 Nm • Install closure plug

Important. Make sure that the fastening bolt does not fall into the clutch housing

13. 13. Attach shift cables • Mount in bracket – Engage retainer • Clip onto ball heads

Note. Make sure shift cables are fitted in correct order

14. 14. Install preheating control unit and relay holder • Clip into bracket
15. 15. Connect battery • Connect ground cable. – Tightening torque 5,5 Nm
16. 16. Program volatile memories
17. 17. Close bonnet.