Home ReviewsRefund
Home/Opel/Vivaro/Opel Vivaro A (2001-2011)/Repair manual/Diesel Engine/Special Service Tools (Group J)
Contents Wiring diagrams Section: Diesel Engine All sections

Special Service Tools (Group J) Opel Vivaro A

Diesel Engine 6 illustrations
KM-412Engine Overhaul Stand
To hold removed engine
KM-412-19-BAdapter
To be used in conjunction with KM-412
KM-498-BPressure Gauge
To check engine oil pressure
KM-911Locking Tool
To lock flywheel (transmission installed)
KM-6031Positioning Pin
To position No. 1 cylinder at top dead centre
KM-6164Oil Filter Wrench
To remove and install oil filter
KM-6210-AEngine Support
To support engine from below
KM-6225Timing Belt Tester
For checking timing belt tension
KM-6234Timing Belt Tensioner
To pre-tension timing belt
KM-6239Locking Tool
To lock diesel pump pulley
KM-6240Extractor
To remove diesel pump pulley
KM-6030Installer
Install camshaft oil seal
KM-812Wrench
Fuel pipe wrench
KM-6241Adapter
Used with KM-533-1 and compression/pressure loss tester
KM-6279Wrench
To install KM-6241
KM-533-1Adapter
Adapter for KM-6241 pressure loss
KM-6292Installer Kit
To install valve stem oil seals
KM-840Pliers
For removing valve stem seals
KM-6407Installer
To install crankshaft bearing shells
KM-6028Installer
To install crankshaft oil seal, timing side (front)
KM-6029Installer
To install crankshaft oil seal, flywheel side (rear)
KM-6405Remover
To remove crankshaft No. 1 bearing cap
KM-6406Remover
To remove piston spray nozzles
KM-6409Installer Kit
To install piston spray nozzles at 3°
KM-6411Installer
To install oil return pipe
KM-652Locking Tool
Flywheel locking tool (Transmission removed)
KM-328-BSide Hammer
For use with EN-48940, to remove lower section of oil dipstick guide tube
KM-328-70Adaptor
For use with EN-48940, to remove lower section of oil dipstick guide tube
EN-48940Remover/Installer
For removing lower section of oil dipstick guide tube
MKM-667Pressure and Vacuum Pump
For checking pressure of turbocharger control actuator
KM-328-7-AAdapter
For use with KM-328-A, to remove crankshaft pilot bearing
KM-J-26516-AInstaller
To install crankshaft pilot bearing
KM-J-8092Handle
For use with Installer KM-J-26516-A
KM-328-6-AAdapter
For use with KM-328-7-A
MKM-571-BDial Test Indicator
For measuring piston and valve protrusion
KM-301DTI Stand
For use with MKM-571-B, to measure piston and valve protrusion
EN-47632Cleaner
To clean fuel injector bores
EN-48088Remover
Used with KM-313 to remove fuel injectors
KM-313Slide Hammer
Used with EN-48088 to remove fuel injectors
KM-6130Locating Pin
To lock ribbed V-belt tensioner

More articles — Engine and Engine Aggregates