Crankshaft Balancer Installation Buick Century VI

Tools Required

1. J 29113 Crankshaft Balancer Installer. See «Special Tools and Equipment»(ref-189348-S03958070272005090900000) .
2. J 36660-A Torque Angle Meter. See «Special Tools and Equipment»(ref-189348-S03958070272005090900000) .

Scheme 466

Scheme 467

1. Apply sealer GM P/N 12346286 (Canadian P/N 10953472) or the equivalent to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.
3. Install the J 29113 onto the crankshaft.
4. Pull the crankshaft balancer into position.
5. Remove the J 29113 from the crankshaft balancer. NOTE: Refer to «FASTENER NOTICE»(ref-175132-S17785009232005041500000) in Cautions and Notices. NOTE: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
6. Install the crankshaft balancer washer and bolt. Tighten Tighten the crankshaft balancer bolt a first pass to 70 N.m (52 lb ft). Tighten the crankshaft balancer bolt a final pass to 85 degrees using the J 36660-A .