- Note direction of connecting rod and cap installation. Ensure connecting rod is installed so front mark at center of connecting rod is toward front of engine. (Схема №17)
- Connecting rod big end bore diameter is indicated by an "A", "B" or "C" size mark stamped on one side of connecting rod. (Схема №17) Ensure big end bore diameter is within specification. See «CONNECTING RODS»(ref-49505-S18084073282001011500000) under ENGINE SPECIFICATIONS.
- Check rod bearing oil clearance using Plastigage. Ensure bearing oil clearance and side play are within specification. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS and «CONNECTING RODS»(ref-49505-S18084073282001011500000) under ENGINE SPECIFICATIONS.
- If rod bearing oil clearance is incorrect, it may be possible to obtain correct clearance using selective service rod bearings. Rod bearings are available in 3 standard service sizes, indicated by a color code on bearing. See «ROD BEARING SPECIFICATIONS»(ref-49505-S05696758832001011500000). Coat nut and threads with engine oil before installing. Tighten nuts to specification. See «TORQUE SPECIFICATIONS»(ref-49505-S22979059872001011500000).
| Color Code | Bearing Thickness In. (mm) |
|---|---|
| Yellow | .0595-.0597 (1.512-1.516) |
| Green | .0594-.0595 (1.508-1.512) |
| Pink | .0592-.0594 (1.504-1.508) |
ROD BEARING SPECIFICATIONS