Recommended Torque Values
Nm
Camshaft bearing cap to cylinder head 20 2)
Camshaft pulley to camshaft 10
Cylinder head cover to cylinder head 8
Cylinder head to cylinder block 40 + 60 to 75° + 60 to 75 °1)
Exhaust manifold with turbocharger to cylinder head 40
Exhaust pipe to turbocharger connection 65
Fuel return line with new seal rings to injector nozzle holder 30
Injection lines to injector nozzle holder and injection pump 25
Injector nozzle holder to cylinder head 50
Intake manifold to cylinder head 25
Oil cooler thermostat connection to cylinder head 30
Rear toothed belt cover to cylinder head and block 8
Sheathed glow plugs in cylinder head 20
Turbocharger support to cylinder block 51
1) Use new bolt(s)
2) Fastening bolts in stages
Note:
When torque angles are specified, tighten bolts to the relevant torque and then turn further by the indicated angle.
Use bolts and nuts once only.