Recommended Torque Values
17 D, 17 DR
Nm
Alternator to bracket (M8) 30
Alternator to bracket (M10) 35
Bracket, alternator to cylinder block 40
Bracket, injection pump to cylinder block 25
Bracket, injector nozzle to cylinder head 70
Bracket, left engine suspension to transmission 60
Bracket, oil pump intake pipe to cylinder block 6
Bracket, power steering fluid pump to cylinder block 40
Bracket, quantity actuation to injection pump 25
Bracket, rear engine suspension to transmission 601)
Bracket, right engine suspension to cylinder block 60
Cable to sheathed glow plug 4
Camshaft housing cover to camshaft housing 8
Camshaft pulley to camshaft 75 + 60° + 5°2)
Clamping bracket to alternator and intake manifold 25
Con-rod bearing cover to con-rod 35 + 45° + 15°2)
Coolant outlet port to thermostat housing 8
Coolant pump to cylinder block 25
Crankshaft bearing cover to cylinder block 50 + 45° + 15°2)
Crankshaft pulley to toothed belt drive gear 20
Cylinder head to cylinder block 25 + 90° + 90° + 45°2)4)
Exhaust manifold to cylinder head 22
Exhaust pipe to exhaust manifold 25
Flywheel to crankshaft 60 + 30° ± 5°2)
Fuel filter to bracket 25
Heat shield to starter 6
Hose to fuel filter 30
Hub of injection pump to injection pump 25
Injection lines to injection pump and nozzle holder 25
Injection pump to bracket 25
Injection pump to support (M6) 12
Injector nozzle holder assembly 70
Intake manifold to cylinder head 22
Left engine damping block to bracket 60
Oil drain screw to oil pan 45
Oil filter to oil pump 15
Oil pan to cylinder block 53)
Oil pressure relief valve to oil pump 30
Oil pressure switch to oil pump 40
Oil pump to cylinder block 6
Oil pump intake pipe to oil pump 83)
Rear engine damping block to bracket 45
Rear engine damping block to crossmember 40
Right and left engine damping blocks to side member 652)
Right engine damping block to bracket 35
Separator (crankcase forced ventilation) to cylinder block 15
Sheathed glow plug to cylinder head 20
Starter support to cylinder block 25
Starter support to starter 7
Starter to cylinder block (engine side) 45
Starter to cylinder block (transmission side) 75
Temperature sensor to thermostat housing 11
Thermostat housing to cylinder head 15
Thermoswitch to fuel filter 15
Thrust plate - camshaft to camshaft housing 8
Toothed belt drive gear to crankshaft 145 + 30° + 10°2)
Toothed belt gear to hub of injection pump 25
Toothed belt guide roller to cylinder block 40
Toothed belt tension roller to cylinder block 25
Transmission to cylinder block (upper and lower) 60
Vacuum pump to camshaft housing 28
Vent bolt to injection pump 25
1) Use new locking plates
2) Use new bolt(s)
3) Insert bolts with Locking Compound 15 10 177 (90 167 347)
Max. assembly time including torque check is 10 min.
4) After warming up, + 30° + 15°
Note:
When torque angles are specified, tighten bolts to the relevant torque and then turn further by the indicated angle.