Crank Drive, Cylinder Block
Flywheel
| Engine | 17 DT (TC 4 EE 1) | ||
|---|---|---|---|
| Starter ring gear | Before fitting, heat ring gear to 180 °C to 230 °C | ||
| Lateral run-out | Permissible lateral run-out of installed starter ring gear to flywheel: | ||
| mm | 0.5 | ||
| Precision turning | Permissible removal of material in clutch disc lining surface area: | ||
| mm | 0.3 | ||
| In order to achieve the functional relationship again after removal of material, the same removal of material must take place on the fore part of the flywheel | |||
| (contact for clutch assembly). | |||
| Engine | 17 DT (TC 4 EE 1) | ||
| Standard dimension | Minimum dimension | ||
| Dimension "A" mm | 19.15 | 18.15 | |
| .P. A712.tif | 4 | 6 | tiff;; |