Crank Drive, Cylinder Block
Cylinder Bore
| Engine | 17 DT (TC 4 EE 1) | |
|---|---|---|
| Rebore cylinder | ||
| Reboring limit | mm | 79.2 |
| After reboring, invalidate original coefficient on | ||
| crankcase and emboss new oversize coefficient. | ||
| Bore | ||
| Permissible out-of-round | mm | 0.0151) |
| Permissible taper | mm | 0.015 |
| Peak-to-valley height of running surface | µm | 1.0 to 3.2 |
1) Measure out-of-round at four different heights in bore