Home ReviewsRefund
Home/Cadillac/Escalade/Cadillac Escalade GMT800 (2001-2006)/Repair manual/Mechanical/Anaerobic Sealer
Contents Wiring diagrams Section: Mechanical All sections

Anaerobic Sealer Cadillac Escalade GMT800

Mechanical ~166 words
  1. Anaerobic gasket eliminator hardens in the absence of air. This type sealer is used where two rigid parts, such as castings, are assembled together. When two rigid parts are disassembled and no sealer or gasket is readily noticeable, the parts were probably assembled using a gasket eliminator.
  2. Follow all safety recommendations and directions that are on the container. To remove the sealant or the gasket material, refer to «REPLACING ENGINE GASKETS»(ref-180687-S40450650212005072800000) .
  3. Apply a continuous bead of gasket eliminator to one flange. Surfaces to be sealed must be clean and dry. NOTE: Refer to «SEALANT NOTICE»(ref-175132-S42059863332005041500000) in Cautions and Notices.
  4. Spread the sealer evenly with your finger to get a uniform coating on the sealing surface. Important: Anaerobic sealed joints that are partially torqued and allowed to cure more than five minutes may result in incorrect shimming and sealing of the joint.
  5. Tighten bolts to specifications. Do not overtighten.
  6. After properly tightening the fasteners, remove the excess sealer from the outside of the joint.

More articles — Engine Mechanical - 4.8L, 5.3L & 6.0L