Replacing Engine Gaskets — Buick Park Avenue II рестайлинг (2002-2005)

Replacing Engine Gaskets Buick Park Avenue II рестайлинг

Do not reuse any gasket unless otherwise specified. Reusable gaskets will be identified in the service procedure. Do not apply sealant to any gasket or sealing surface unless called out in the service procedure.
Use a rubber mallet in order to separate components. Bump the part sideways in order to loosen the components. Perform the bumping at the bends or at the reinforced areas in order to prevent the distortion of components. IMPORTANT: Do not use any other method or technique in order to remove the gasket material from a components. Do not use the following items in order to clean the gasket surfaces: Abrasive pads Sand paper Power tools These methods of cleaning may damage the component. Abrasive pads also produce a fine grit that the oil filter cannot remove from the oil. This grit is abrasive and may cause internal engine damage.
Remove all of the gasket and the sealing material from the component using a plastic or a wood scraper. Do not gouge or scrape the sealing surfaces. IMPORTANT: Do not allow the sealant to enter any blind threaded holes. The sealant may cause the following conditions: Prevent you from properly seating the bolt Cause damage when you tighten the bolt
When assembling components, use only the sealant specified in the service procedure. Ensure that the sealing surfaces are clean and free of debris or oil. When applying sealant to a component, apply a bead size as specified in the service procedure.
Tighten the bolts to the specifications.

Replacing Engine Gaskets Buick Park Avenue II рестайлинг