MONTEREY MULTEC M Trouble code Table
Trouble
| code | Information sensor |
|---|---|
| Cause of Fault | Directions for Remedy in |
FO:DATA LIST
| No. | Trouble code storage when ... | Remarks |
|---|---|---|
| 42 | Fault in ignition system DIS | |
| 9,10,12 | · During the engine start process, the control module has detected a voltage value at output, terminal D5 to the ignition module (EST line) which does not conform to the nominal value. |
· During the engine start process, the control module has detected a voltage value at output, terminal D11 to the ignition module (BYPASS line) which does not conform to the nominal value.
If trouble code 42 has been detected, the EST line is turned off. The ignition point is monitored by the DIS module.
The DIS system is in emergency mode
If trouble code 42 has been detected, the control module switches the engine control lamp on.