Home ReviewsRefund
Home/Opel/Agila/Opel Agila B (2008-2011)/Repair manual/Engine Mechanics - D13A/Engine Oil Pressure Check
Contents Wiring diagrams Section: Engine Mechanics - D13A All sections

Engine Oil Pressure Check Opel Agila B

Engine Mechanics - D13A 2 illustrations ~185 words

Remove

  1. 1. Remove trim cover from engine • Remove 4x bolt
  2. 2. Remove oil pressure switch (1) from cylinder head • Place collecting container below • Disconnect harness connector

Measure

  1. 3. Install Adapter KM-135 to cylinder head
  2. 4. Install Fluid Pressure Gauge KM-498-B to Adapter KM-135

Important. Ensure the engine is at normal operating temperature before checking the engine oil pressure.

  1. 5. Measure engine oil pressure at idle • Start engine, then run engine at idle • Oil pressure is within specification if recorded pressure is 100 kPa (Min.)
  2. 6. Measure engine oil pressure at 4000 rpm • Raise engine speed to 4000 rpm • Oil pressure is within specification if recorded pressure is 300 - 400 kPa (Min.)

Note. 2x technician are required.

  1. 7. Stop engine
  2. 8. Remove Fluid Pressure Gauge KM-498-B from Adapter KM-135
  3. 9. Remove Adapter KM-135 from cylinder head

Install

  1. 10. Install oil pressure switch (1) 32 Nm to cylinder head • Apply suitable sealant to threads of oil pressure switch • Connect harness connector
  2. 11. Install trim cover to engine • Install 4x bolt 8 Nm

More articles — Engine