Home ReviewsRefund
Home/Kia/Soul/Kia Soul I рестайлинг (2011-2014)/Repair manual/Automatic Trans/Automatic Transaxle System - General Information - 1.6L: Ot…
Contents Section: Automatic Trans All sections

Automatic Transaxle System - General Information - 1.6L: Other Kia Soul I рестайлинг

Automatic Trans ~190 words

Sensors

Input Speed Sensor

  1. Type: Hall effect sensor
  2. Specifications
Operation condition (°C)°F((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.(1.2 ~ 1.8) 0.0472 ~ 0.0709
Output voltage(V)High1.18 ~ 1.68
Low0.59 ~ 0.84

Output Speed Sensor

  1. Type: Hall effect sensor
  2. Specifications
Operation condition (°C)°F((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.(0.85 ~ 1.3) 0.0335 ~ 0.0512
Output voltageHigh1.18 ~ 1.68
Low0.59 ~ 0.84

Oil Temperature Sensor

  1. Type: Negative thermal coefficient type
  2. Specifications
Temp.[(°C)°F]Resistance (kohms)
(-40)-4048.1
(-20)-4.015.6
(0)32.05.88
(20)68.02.51
(40)104.01.11
(60)140.00.61
(80)176.00.32
(100)212.00.18
(120)248.00.10
(140)284.00.06
(150)302.00.05

Inhibitor Switch

  1. Type: Combination of output signals from 4 terminals
  2. Specifications
Power supply (V)12
Output typeCombination of output signals

Solenoid Valves

Direct control VFS[26/B, T/CON]

  1. Control type: Normal low type
Control Pressure kpa (kgf/cm 2 , psi)9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54)
Current value(mA)50 ~ 850
Internal resistance(ohms)5.1

Direct control VFS[UD/B, OD/C, 35R/C]

  1. Control Type: Normal high type
Control Pressure kpa (kgf/cm 2 , psi)500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)
Current value(mA)50 ~ 850
Internal resistance(ohms)5.1

Line Pressure Control VFS

  1. Control type: Normal high type
Control Pressure kpa (kgf/cm 2 , psi)500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)
Current value(mA)50 ~ 850
Internal resistance(ohms)5.1

ON/OFF Solenoid Valve(SS-A, SS-B)

  1. Control type: Normal low type
Control pressure kpa (kgf/cm 2 , psi)490.33(5.0, 71.12)
Internal resistance(ohms)10 ~ 11
SS-ASS-BUD/B-VFSOD/C-VFS35R/C-VFS26/B-VFS
N/HN/HN/HN/L
N, P
1
2
3
4
5
6
L
R
Connected status : Connected at vehicle speed above 8km/h

SOLENOID VALVE OPERATION TABLE

Lubricants

ItemSpecified lubricantQuantity
Transaxle fluidSK ATF SP-IV, MICHANG ATF SP-IV, NOCA ATF SP-IV, Kia Genuine ATF SP-IV or other brands meeting the above specification approved by Kia Motors Corp.7.3L (1.93 U.S gal., 7.71 U.S.qt., 6.42 lmp.qt.)

Sealant

ItemSpecified sealant
Rear coverLOCTITE FMD-546(P/N: UM010CH046) or equivalent or THREE-BOND TB1281B
Torque converter housing

Special Service Tools

Tools (Number and name) Illustration Use 09200-38001 Engine support fixture (Beam) Removal and installation of the transaxle. Except lower supporter, use beam only with new engine support fixture supporter(SST No.:09200-2S000) 09200-2S000 Engine support fixture (supporter) Removal and installation of the transaxle. [Using with handle (SST No.:09200-38001)] 09200-4X000 Engine support fixture (adapter) Removal and installation of the transaxle. [Using with handle (SST No.:09200-38001) and supporter(SST No.: 09200-2S000)] 09452-26100 Oil seal installer Installation of transaxle case oil seal. [Using with handle (SST No.:09231-H1100)] 09231-H1100 Bar Installation of transaxle case oil seal. [Using with oil seal installer (SST No.:09452-26100)]

More articles — Automatic Transaxle System - General Information - 1.6L