Home ReviewsRefund
Home/Kia/Optima/Kia Optima III (2010-2013)/Repair manual/Testing & Diagnostics/Evaporative Emission Control System - Hev: Removal & Instal…
Contents Wiring diagrams Section: Testing & Diagnostics All sections

Evaporative Emission Control System - Hev: Removal & Installation Kia Optima III

Testing & Diagnostics ~142 words

Installation

Installation is the reverse of removal.

Canister installation bolt

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Canister protector installation bolt

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Auxiliary canister installation bolt

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

  1. Install the component with the specified torques.
  2. Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  1. Install in the reverse order of removal.
  1. Install the component with the specified torques.
  2. Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  1. Installation is reverse of removal. NVLD installation bolt: 2.3 ~ 3.3 N.m (0.2 ~ 0.3 kgf.m, 1.7 ~ 2.5 lb-ft)

More articles — Evaporative Emission Control System - Hev